GMC Truck Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
So I have a 2007 Chevy silverado 1500 4.8 V8
And I started noticing the tranny leak so I looked under and seen the outputshaft seal and bushing were both popped off
So I tried replacing bushing but didn’t fit right so I ordered new tail shaft extension housing came with bushing and seal installed
Drove it for the day and AGAIN bushing and seal came off WHY IS IT DOING THAT??
also I noticed my slip yoke comes out more then it should
 

·
Registered
Joined
·
2,898 Posts
Extreme pressure build up in the trans, or vibration in driveshaft. Regardless If the bushing came out, your yoke is done with, and driveshaft needs to be rebalance
 

·
Registered
Joined
·
2,898 Posts
No. Pick out the outshaft on your trans. Is toasty
 

·
Registered
Joined
·
2,898 Posts
Pick up on the out put shaft, and see if it moves.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top