GMC Truck Forum banner
1 - 1 of 1 Posts

·
Yuuuuuppppppp
Joined
·
1,055 Posts
Discussion Starter · #1 ·
The Rancho 4” just drops the lower control arms, slaps a bigger knuckle in and uses spacers for the axles correct? There is no cutting or IFS dropping needed correct? Yes I searched but didn’t see much.

Looking to clear 35/12.50 20s on a 20x9/8.5 with very moderate BS/Offset. I don’t mind trimming. Truck will be used on street 97.592% of the time.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top