GMC Truck Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
2,723 Posts
Discussion Starter · #1 ·
Will 4wd spindles from a NBS, fit my 2wd NBS? I am not looking for any lift, just want them to make my 2wd the same height as factory.

Figured this would be the best place to ask, since 2wd and 4wd are commonly lifted.
 

·
230+no stall
Joined
·
30 Posts
yes if your talkin bout the part that pivots thats between upper and lower control arm.. they are the same part number,,, just make sure ur using a 2wd hub because the 4wd 1 requires a cv shaft to run thru it and bolt togeather which keeps the bearing togeather
 

·
230+no stall
Joined
·
30 Posts
i know that the drop spindles sold for our turcks fit both 2wd and 4wd beacuse they both have the same 3 bolt design and bore diameter... which is also on stock ones
 

·
Registered
Joined
·
2,723 Posts
Discussion Starter · #7 ·
I know they would bolt up, I was just worried that a 4wd spindle would make my truck sit taller. I had a feeling that was the case b/c if it was true, guys with 2wd would be always trying to grab 4wd spindles, for a cheap lift. But, that is not the case.
 
1 - 7 of 7 Posts
Top