GMC Truck Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
184 Posts
Discussion Starter · #1 ·
Hey all, I'm going to be under a bit of a time crunch once I actually start to tear the truck out (need to finish the system that same weekend), so I'd like to get as much prep work as possible done beforehand to make it go quicker...does anyone have a template with measurements I could use to cut the MDF/deadener for the back wall of an 04 ECSB? The board doesn't have to be exact, of course, but if i could have the deadener pre-cut that'd save me a shitton of time.

TIA if any of you bother to save your templates :)
 

·
Registered
Joined
·
606 Posts
heres a pic of mine. the piece of mdf I used was 14"x48" and I made some brackets for it so it bolts in with the seat belts.
DSC01980.jpg
 

·
Registered
Joined
·
606 Posts
let me know if you have anymore questions because I just did all mine last week.
 
1 - 3 of 3 Posts
Top