GMC Truck Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
256 Posts
Discussion Starter #1
I have a 98 sierra 4X4 with 3/4" lowering kit installed and I want it a little lower in the rear. If I remove the rear lift blocks can I just leave the springs on the axel and I need to buy shorter u-bolts also, right?

I've done alot of reading and I don't see too many people with obs trucks removing lift blocks... anyone done this?
 

·
Registered
Joined
·
8,303 Posts
You are correct.

Unbolt u-bolts, take out block, align axle pin into the spring and bolt up new u-bolts. Chances are you'll need shorter u-bolts, but it's a good idea to replace them anyway. They can bend over time.
 
1 - 2 of 2 Posts
Top