GMC Truck Forum banner

Removing the factory blocks ..

787 Views 3 Replies 4 Participants Last post by  BDZ71
Can this be done myself.. ? And how can I remove the factory blocks in the rear? I could sure use that 2inches of lowering.. :D
1 - 1 of 4 Posts
jack the rear of the truck up using the frame, pop off the ubolts and take them out. lower the springs back down onto the axle, i'm not sure if there is a centering pin on the axle or not. make sure the springs sit flush on the axle and are lined up and retorque the nuts. an impact wrench is handy.
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top