GMC Truck Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,019 Posts
Discussion Starter #1
I'm look to finally get around to adding the matching rear Fab Fours bumper, but I want to add a pair of Rigid Industries Dually Flush Mount lights in place of the pair of Fab Fours logo cutouts to act as reverse/work lights. Here's the setup I'm looking to do on a Tundra:

FabRigid.jpg


I want to replace this standard Rigid red-lense rocker switch that comes with the kit:

RigidRockerSwitch.jpg


Here's a link to Rigid's wiring diagram: http://www.carid.com/images/rigid-i...pdf/dually-d2fm-installation-instructions.pdf

This OTRATTW rocker switch is the one I want to use:

7758B-01.jpg


CONTURA V, BACKUP LIGHTS, UPPER DEPENDENT LED ONLY

•SPST ON/OFF switch.
•GREEN LED
•Upper GREEN LED is ON when the upper part of the rocker is pressed ON. This will light up the symbol area.
•NO LOWER LED
•Rated 20A 12V
•No rear barriers between terminals. VCH housing connectors can be used with Packard 630 terminals. VCH connector and terminals are sold separately.
•Insulated 1/4" female quick disconnect terminals can also be used. This is a 3 terminal switch

Here's a link to the OTRATTW's wiring diagram: http://www.otrattw.com/B60.pdf


It appears both rocker switches are a 3 terminal switch. Do you see any reason why the OTRATTW rocker switch would not be a direct replacement for the Rigid rocker switch?

Thanks for y'alls input!
 
1 - 3 of 3 Posts
Top