GMC Truck Forum banner
1 - 1 of 1 Posts

03 Tahoe
1,364 Posts
Discussion Starter · #1 ·
Ok, when I went to check on my truck last week, I was checking everything out killing some time. I noticed, on my pass side, the tabs on the upper bar 4 link bracket were shearing off and bent. The driver side was ok but looked slightly bent. I did some general quick measuring and calculating and everything is square and true. Here are some pics I took....sorry for the fuzzy pics...

I have emailed ART but haven't heard back. This is really odd....not sure what to think. The lower bars look fine to distortions or bent equipment. Just the uppers mounts on the frame. Any ideas? Anything to look for? I though that it could have been caused by a lot of axle deflection from ride height to laid out but it doesn't seem to be the issue.

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.