GMC Truck Forum banner
1 - 9 of 9 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
if my calculations are right a short box tonneau and a over the rail toolbox should match up perfect on my 8 ft. box anyone tried this or seen it done?
tonneau would be free so its a good option if it works...
 

·
is Bi-Winning and a
Joined
·
8,241 Posts
You would have to seal it to the tool box up front. Also wouldnt it need to have room at the cab/toolbox to open?
 

·
not low enough
Joined
·
8,703 Posts
they make covers for this reason. lol why buy one not made for this?
 

·
Registered
Joined
·
10 Posts
Discussion Starter · #8 ·
well the math sounded right to me the box is 8 ft with a 18 inch tool box that cuts it down to 6.5 feet sealing it would probably be the hardest part thanks for the replies
 

·
Desert Rat
Joined
·
3,705 Posts
i have seen it but it was a cover for a OBS and it was on a OOBS or an OOOBS. looked stupid, dont do it
 
1 - 9 of 9 Posts
Top