GMC Truck Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
I haven't seen a Sportster installed like this in any searches so I thought I would post some pics of my install.

I didn't really like the suction cup method on the windshield, the vent bracket or the special bracket so I came up with this in my 2000 Tahoe.

I used the vent bracket without the provided clips. I wrapped the bottom part of the bracket that you use to adjust the angle of the bracket with one of those velcro cable wraps to give it some thickness then inserted it into the tape deck. Inserting into the right (wide) side of the tape deck and slid it to the left to lock it in place. It works pretty well, does not move or try to slide out at all.

Anyway, just thought some people might like to see another option. Here's some pics, click to enlarge





 

·
Wanna B Jack o all Trades
Joined
·
9,823 Posts
personally I like to use the Bracketron custom 99-07 Chev bracket that sticks out the pass side of the dash and bolts on behind the bezel, but that does look ok in the small pics
 
1 - 4 of 4 Posts
Top