[ohasson66]

Currently have a 2 inch pro comp leveling kit installed, and i want to add some spindle source spindles, will i need an alignment and or new UCAS. secondly if i leave the rear end stock (for now) is there anything else to mettle with?

 

[brucebruce45]

Yes, probably, and personal preference

 

[Truckaddict]

Yes on alignment, ucas you might as Bruce said its all personal prefrence, the rear is all preferences again..

I have 3" spindles and 2.5" level, no new ucas but I did buy new shocks it needed a alignment but rides great. No complaints

 

[ohasson66]

Yes on alignment, ucas you might as Bruce said its all personal prefrence, the rear is all preferences again..

I have 3" spindles and 2.5" level, no new ucas but I did buy new shocks it needed a alignment but rides great. No complaints

Did you buy new shocks for the front or rear or both? I'm trying to figure out what the best way to tackle this lift is

 

[Truckaddict]

Did you buy new shocks for the front or rear or both? I'm trying to figure out what the best way to tackle this lift is

Ended up buying new for both because I put a bigger block then the stock rear shocks could handle. Both sets are bilstien 5100

 

[truefire04]

from my understanding you shouldn't need new shocks with a spindle lift only. only when you go with more then a 1" coil spacer or spring lift.