Spindle lift

1097 Views 5 Replies 4 Participants Last post by truefire04, Mar 8, 2015

ohasson66

Discussion Starter · Mar 7, 2015

Currently have a 2 inch pro comp leveling kit installed, and i want to add some spindle source spindles, will i need an alignment and or new UCAS. secondly if i leave the rear end stock (for now) is there anything else to mettle with?

Save

1 - 2 of 6 Posts

Truckaddict

· #3 · Mar 7, 2015

Yes on alignment, ucas you might as Bruce said its all personal prefrence, the rear is all preferences again..

I have 3" spindles and 2.5" level, no new ucas but I did buy new shocks it needed a alignment but rides great. No complaints

Save

Truckaddict

· #5 · Mar 8, 2015

ohasson66 said:
Did you buy new shocks for the front or rear or both? I'm trying to figure out what the best way to tackle this lift is

Ended up buying new for both because I put a bigger block then the stock rear shocks could handle. Both sets are bilstien 5100

Save

1 - 2 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month