GMC Truck Forum banner
1 - 2 of 7 Posts

· Jason RIP
9,790 Posts
Downfall said:
i was working on my dash bezel and had everything looking good and went to spray the clear and something had gotten into the clear when it was drying or something and it looked all digny so i tried to sand some off but them i accidently sanded a lil too deep and it just kinda snowballed from there... basically i was inpatentent with the sanding so i fucked it up
did it look dingy or milky? Clear as it dries will look milky but if you give it long enough it will get crystal clear.

Also, sounds like if you has just let it dry throughly you could have sanded it down some and reshot it without having to have stripped the whole thing, the only reason you would have needed to strip it all was if you had a bad chemical reation with the paints and it turned to gunk.
1 - 2 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.