GMC Truck Forum banner

1 - 4 of 4 Posts

·
Southend Terror Squad
Joined
·
36 Posts
Discussion Starter #1
Well I just got back from the alignment shop after replacing my tie rod and apparently I have bent the passenger side control arm brackets. Anyone know when I can get just the brackets?
 

·
Bayou Surface Drive, LLC
Joined
·
7,077 Posts
PM Hellfire, He works for superlift, and will probably fix you up. DID you wheel the truck hard? Are you the one who broke the TRE in that deep hole?
 

·
Registered
Joined
·
2,584 Posts
I've seen this happen on the bracket kits for both the FS trucks and S-10s (actually the one on the ZR2 cracked) I know that SL sent out new parts free of charge to the 2 people that had it happen on their trucks (the '95 ZR2 and a '99 Z71)...they were both original "owners" of the lifts. Might be a judgement call for SL, though.
 

·
Southend Terror Squad
Joined
·
36 Posts
Discussion Starter #4
Yea, I was the one who fell in the hole. It's barely bent back, maybe a 1/2 inch, but the alignment guy it wouldn't hurt a whole lot since he got the tire sitting straight. The passenger tire would just be back a little and rub some.
 
1 - 4 of 4 Posts
Top