GMC Truck Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
115 Posts
Discussion Starter · #1 ·
ok here is my question, all my valves are 1/2 inch valves, and i bought a kit that came with 1/2" T's, the kind were you push the tube in teh t and tighten the nut to lock the tubein place and crush the little caller inside. Now thje threads on the T look to be fine thread and the threads on the valve are larger more course threads, how would i connect the 2, i know to use a couplier but i am unable to find one that will fit the fien and course threads of both??
 
1 - 2 of 2 Posts
Top