GMC Truck Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
5,693 Posts
some adhesive remover and a piece of fishing line to get it started. just spary it with the adhesive remover and let it sit for a few min., that slide the fishing line behind to remove it. if you use the adhesive remover, be sure to wash and wax the spot where you used it.
 

·
Burning Rubber
Joined
·
994 Posts
get a heat gun from home depot...... it'll help alot
 

·
Registered
Joined
·
785 Posts
me and builtnotbought grabbed ahold of the molding and it came right off, of course it was on a new truck so the molding hadn't been on there very long, the only problem I had was with the tailgate, the dang silverado and chevrolet emlems were a PITA, no probs now it's shaved up
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top