GMC Truck Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
215 Posts
Discussion Starter #1
so last nite was a bad nite for the truck. it went through a lot of stuff. now when i do about 45 or so i hear some type of grinding noise. could this be my u joint? it sounds like its coming from the t-case area. my driveshaft hasn't been legnthed yet. could that cause it? also where is the best spot to get one for the rear. and btw it happens when i am in two wheel drive. also when i put it in four.
 

·
cracker ass fantastic
Joined
·
616 Posts
it could be a u joint twist the drive shaft and see if the uj turns in the yoke
 

·
Bayou Surface Drive, LLC
Joined
·
7,077 Posts
go evaluate the problem. if the joint has slack might be time to replace it. Do you perform maintanence on the drive line?
 
1 - 3 of 3 Posts
Top