GMC Truck Forum banner

1 - 5 of 5 Posts

·
Drive It Like Ya Stole It
Joined
·
6,656 Posts
Discussion Starter #1
Ok well I just ordered some for my axles. Anyone who has used it have any tips? I ordered the following:

Marine-Clean
Metal-Ready
POR-15
Topcoat
High Heat shit - to use on the calipers.

Any input would be apreciated.
 

·
Registered
Joined
·
496 Posts
wear gloves it doesn't wash off your skin, you have to wait for it to wear off. spread it on in multiple super thin layers or it will bubble as it drys. a little bit goes a long ways
 

·
Registered
Joined
·
122 Posts
I used it on my 14 bolt with decent results. The rust wasn't that heavy so I just went over parts of the axle with some sand paper then used this metal cleaning solution over the entire housing. Let it all completely dry then brushed it on in 3 thin layers. It seemed good for a few months then after some wheelin trips it started to flake off pretty bad in spots. I'd say just prep as best as you can, I didn't use their cleaning solution so you might have better results using that.
 
1 - 5 of 5 Posts
Top