GMC Truck Forum banner
1 - 5 of 5 Posts

·
HOT AIR BALLOON OWNER
Joined
·
14,932 Posts
Discussion Starter · #1 ·
Anyone used this with good quality results when applied PROPERLY? lol

I put it on the LTs on my F150 but being a dumbass I didn't heat cycle the headers so the coating blistered and came off. :buttkick:

There's a set en route to my casa as we speak and I plan to clean them up then put them on my BBQ pit to heat treat them on slowly increasing heat to heat cycle them...

So, I was wondering if it'll hold up well or not.

:think:
 

·
GMFS slowest truck :read:
Joined
·
5,501 Posts
yum...bar b qued headers... :rocking:...

i dunno if it will work or not, but it would be cool to find out.
 

·
HOT AIR BALLOON OWNER
Joined
·
14,932 Posts
Discussion Starter · #3 ·
Well, if no one knows...I'll tell ya guys.

I plan to heat them for 30 min on then 30 off.

Low heat, med heat, then high heat...
 

·
Broke
Joined
·
350 Posts
Never used that paint properly. Had them on the engine for a while then turned it off, then on for a while then off, etc...

Burned off in some spots are a few months....
 

·
HOT AIR BALLOON OWNER
Joined
·
14,932 Posts
Discussion Starter · #5 ·
Yeah see, I've never heard of anyone using it properly! :jester:

I thought about puttin' it in my oven...but that'd be bad as I bake lots of pies and cookies. lol

Gimme about two weeks and I'll give this stuff a whirl. :shake:
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top