GMC Truck Forum banner

which offset?

628 Views 3 Replies 3 Participants Last post by  z28camaro1996
on my 91fullsize chevy what off set should i run? its lowered 4/6 inch and i dont want to rub. im going to go with a 20'' rim.
1 - 4 of 4 Posts
Look under "Street Suspensions" under "Tuckable Rim Chart" this is very helpful. Also the link below gives you a virtual look at what you want to achieve.

Good luck. I have a 94 and finding 5/5 with a high positive offset is proving to be very difficult. Be sure that the wheels that you order have a center bore of 78.3mm or they will not fit over the hub. The newer Jeeps run a 5/5 with a center bore of 71mm which is too small unless you have the ability to machine them larger.

After a month I still haven't found any wheels to fit without rubbing the fender. I am looking for 18s and only found one wheel that I have to get the manufactuer to cut special.

If there is anyone out there that can help I am still looking.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.